How to View CardioMEMS Waveform Data

*Please note the screenshots and information in this article contain fake PHI*

If a patient is using a PA Pressure Sensor, you can view the waveform data from their daily transmissions in Rhythm360.

Viewing waveform data

There are two ways to view PA Sensor waveform data. You can either click on the datapoint in the patient's trends graph, or view them from the measurement window.

Both methods require you to first navigate to the patient's profile page. You can do this by clicking on the patient's name in the Dashboard, going to the Patient List, or by searching for the patient in the search bar.

To view PA Sensor waveform data from the trends graph:

1. Scroll to the device trends graph. This graph displays a summary of the patient's measurements. 
2. Hover your cursor over the graph's data points until you see a window appear. The window will display a date, and the patient's measurements for that date.
3. Click the data point to open a new window. The new window displays the patient's waveform reading for that date.

To view PA Sensor waveform data from the measurement window:

1. Scroll to the device trends graph. On the right hand side of the graph, click View Measurements.
2. A new window will appear, displaying a graph of the patient's previous measurements.
3. Make sure to select PA sensor then click the waveform button next to each measurement to open a new window. This window will display the waveform reading.

Ignoring waveform readings

If you believe a waveform is a suspect reading and should not appear on the trends, open the waveform reading using the steps described above click Mark as Suspect (Ignore), and click Yes to confirm. The waveform will be hidden from the trends.